PDA

View Full Version : How many PWM?



Mindcrime13
08-21-2008, 02:52 PM
hello, im planning my set up using 2 HHO cells, would i need 2 PWM or one?

thanks!

Dewayne
08-21-2008, 03:14 PM
IMO you would need two, one for each cell. The reason for this is no two cell are alike and each one will have it's own resonate frequency.

godoveryou
08-21-2008, 03:22 PM
Depends. Are you going to finely tune the PWM's each time you start your car? If not, then it doesn't matter, because you won't be anyplace close to the frequency required for super high production anyways.

Mindcrime13
08-21-2008, 03:56 PM
Depends. Are you going to finely tune the PWM's each time you start your car? If not, then it doesn't matter, because you won't be anyplace close to the frequency required for super high production anyways.

so how the connection would be from 1 PWM to 2 cells?

godoveryou
08-21-2008, 04:40 PM
What's the current limit of your PWM? Make sure your cell's don't draw more current together then it's limit. Just wire them in parallel.

Mindcrime13
08-21-2008, 04:43 PM
What's the current limit of your PWM? Make sure your cell's don't draw more current together then it's limit. Just wire them in parallel.


so if the pwm is a 30 amp, each cell cannot draw more than 15?

godoveryou
08-21-2008, 05:21 PM
Well likely more along the lines of 12-14a. There will be greater resistance than would be otherwise evident by running them in parallel. The more I think about it, you may have been right to get two just from a current standpoint. My initial answer may have been a bit short sighted. I just don't agree with getting 2 from a resonance standpoint.

Mindcrime13
08-24-2008, 01:05 AM
would a 60 amp pwm work for 2 cells?