PDA

View Full Version : a question for electronics gurus here!



Mindcrime13
09-02-2008, 03:26 PM
i know this does not have very much to do with HHO, but i dunno were to post it

but i need to build this for my rear O2 sensors, since i do not have cat converters, this is a mil eliminator:
http://atomicinternet.homeip.net/teamneco/howtoimages/scem.gif
http://atomicinternet.homeip.net/teamneco/howtoimages/scem.gif

ok the resistor goes in between the Grey wire,

and my questions the micro farad capacitor, it goes hook between the 2 wires?

thanks!

dennis13030
09-02-2008, 08:13 PM
I do not understand your message. The link you provided does not work(shows blank).

I am an electronics eng. I have to understand what it is you need to know.

Mindcrime13
09-02-2008, 10:42 PM
agh, crappy link, im sorry for that

heres the link complete

http://atomicinternet.homeip.net/teamneco/listHOW.asp?RecordID=8

the blueprint is in the bottom, thanks for your help!!

dennis13030
09-03-2008, 12:22 AM
agh, crappy link, im sorry for that

heres the link complete

http://atomicinternet.homeip.net/teamneco/listHOW.asp?RecordID=8

the blueprint is in the bottom, thanks for your help!!

The resistor and capacitor are mounted on a proto-board. This is available at Radio Shack. It takes a little soldering to complete.

See the revised schematic. I think this is right.

Mindcrime13
09-03-2008, 12:35 AM
alright so i put the resistor and the capacitor on the board, and on the bottom of the board i solder them together like in the drawing?