PDA

View Full Version : 6 wire MAF connection help



The_Guy
04-05-2009, 10:12 PM
hello forum,
Another question. I already finished installing my HHO system and without any ECU modes I actually increased my gas milage from 15 mpg to 17 mpg. This makes me a beliver. The cool this about this is that my 2001 Mercury Mountaineer 5.0L V8 first started off loosing 1 mpg for 3 days then when to 17 after. I had a Air/Fuel gauge at the time and for the first 3 days I noticed it running rich while accellerating and normal when idle. Now its running normal when accellerating and lean when at idle. Is it possible that the computer is actually learning on its own? I have no check engine light.

My question is that I purchased a MAF enhanser with 3 wires and I just need to locate the signal wire. My MAF has six wires and the red and black wire are obvious plus I checked them with a voltmeter. Those are out of the question. The problem is not knowing which one is the signal wire.

1 - .08V
2 - 12V
3 - Ground
4 - nothing
5 - .01V
6 - 4.57V

Any idea? 1-3 I believe are the MAF and 4-6 is some kind of heat senser or something like that.

Painless
04-05-2009, 10:35 PM
My guess would be that it's the wire with 4.57v, but I recommend you tap into the wire with the engine running and work the throttle on and off, if it's the correct wire the voltage should change.

The_Guy
04-06-2009, 08:51 PM
thx again.
The sad part is they all go up when the engine is running and when I step on the gas.

1 - .08V to .09 up to .11
2 - 12V to 13.67
3 - Ground
4 - nothing stays the same
5 - .01V stays the same
6 - 4.57V to 4.86V

This is why I am lost.

Painless
04-06-2009, 11:14 PM
Hmm, looks like it may be time to seek some tech manuals or advice of an ASE?

karl.uk
07-19-2009, 02:31 PM
might be a bit late, but if you restrict the air flow by putting your hand over the air intake pipe the voltage on the signal wire should drop as the engine goes to stall due to the lack of air.