PDA

View Full Version : New HHO Generator and Bubbler Design - Yeh Mon



you2wire
07-14-2008, 06:03 PM
I have finally finished my design

Attached are 2 designs

(1) - 10 Plate HHO Generator
(1) - Bubbler

I hope this design will help everyone. tell me if I need to make any changes to the design.

I will finish putting eveything together during this week. Once i finish I will provide actual pictures.

Feedback would be great

mikestrikes
07-14-2008, 10:23 PM
Why not put 3 more neutral plates in between the center + & - ?

All looks great.......

countryboy18
07-15-2008, 07:40 PM
it looks like a great cell plans to me let us know how it preforms. what type of container are you putting in it.

you2wire
07-15-2008, 08:00 PM
I am making two cells 1 am putting it a 4" PVC pipe and the other in a waterproof electrical box.

I should finish it by Sunday

ranger2.3
07-15-2008, 09:48 PM
Looks great!!!I have a similar design that also incorporates 4" PVC

countryboy18
07-15-2008, 10:22 PM
will there be any problems with geting the cell air tight. with the threads

Roland@KnR
07-15-2008, 10:24 PM
This may sound dumb due to me being a newbie but how are the negative plates in the middle of the cells connected?

daveczrn
07-15-2008, 10:39 PM
This may sound dumb due to me being a newbie but how are the negative plates in the middle of the cells connected?

they are not connected. but they do conduct electricity so they will produce gas.

Roland@KnR
07-15-2008, 11:28 PM
Ok so having a + nnn would be a Positive connection to the first plate and the other three would not ne connected to anything other than the conductive water as long as I had a negative in there to?

dennis13030
07-16-2008, 01:01 AM
Ok so having a + nnn would be a Positive connection to the first plate and the other three would not ne connected to anything other than the conductive water as long as I had a negative in there to?

The text in the drawing is NOT correct. RED is the anode, GREY is a neutral and BLACK is the cathode.

countryboy18
07-16-2008, 04:45 PM
so how is the cell working. is that wiring in Series or Parallel . i have yet to under stand when to use each one.

ranger2.3
07-17-2008, 12:12 PM
I will start experimenting with different designs including this design.

countryboy18
07-17-2008, 01:08 PM
hate to say this but it it wont fit. a 4 inch pipe can fit a 2 13/16 square. so you only have a max with of 2 3/4 to work with across in any driection the plates ar exactly 2 3/3 wide "across" and 1/4 deep so only 10 plates with no nuts or washers in the middle of the plates will fit. i may be wrong i wasent the smartest kid in math class but just a heads up.