PDA

View Full Version : how to drop voltage?



chris0147
07-22-2010, 05:48 PM
Hi guys,

I need your advice. I took the reading of the voltage in both end of the plates, there was 12.73v. It was too much voltage in the current to cause heat. I would like to know how to make the voltage drop??



I tried to used correct wire, 15amps ring terminals but it doesn't seen to help.


Please help! :(

chris0147
07-23-2010, 01:22 AM
anyone????????

lhazleton
07-23-2010, 06:04 AM
Chris,
This is the way the plates should be set up:
Positive wire~+NNNNN-~Negative wire.
With 1 cathode plate, 1 anode plate, and 5 neutral plates, 12.7vdc will give you 2.1 vdc per cell. Perfect for splitting the water molecules into H2 & O.

chris0147
07-23-2010, 01:24 PM
Thank you for the answer. I am bit concerns with the short circuits. So, are you sure that is it safe to try it out while the electrical would get into the water to make the bubblers before returns to the battery??