PDA

View Full Version : Radial cell production pattern (pics)



Jaxom
08-18-2008, 06:37 PM
Most of you know that I put together a cell with a slightly unorthodox design. The electrodes are not parallel to each other, instead they radiate out from the center of the cell like spokes on a wheel. This has led to some curiosity about the production distribution of the cell, mainly whether the electrodes produce at the center more than the outer edges. I finally got the cell (well, half of it anyway,) into a clear container so I could see the actual production and get pics of how it was distributed. I was surprised by what I found.

The only container I could easily come up with was a two-liter soda bottle with the top cut off of it. It only had the capacity to hold the bottom half of my cell, so during these tests I cut the current flow down to a little over half what I've been running. These shots are taken at 12.5V and 10-12A.

This is a shot of the cell approx. 2 seconds after startup.
http://i302.photobucket.com/albums/nn120/daveczrn/23dc1784.jpg


This is a closeup of the cell from a low angle, it shows how the production is surprisingly even all the way to the outer edges of the electrode plates.
http://i302.photobucket.com/albums/nn120/daveczrn/15a9177f.jpg


This is a shot after about 30 seconds of run-time. I just threw it in for illustration.
http://i302.photobucket.com/albums/nn120/daveczrn/0576363a.jpg

Jaxom
08-18-2008, 06:46 PM
I also found that the camera I'm using is capable of 3-shot bursts, so I took a startup progression to show that the production is even all the way across the plates, even on intial startup. Thanks again Dave for hosting these for me.

http://i302.photobucket.com/albums/nn120/daveczrn/d0e692b7.jpg


http://i302.photobucket.com/albums/nn120/daveczrn/591e01e5.jpg


http://i302.photobucket.com/albums/nn120/daveczrn/4613d900.jpg

c02cutter
08-18-2008, 07:15 PM
Awesome, love the container too!!! This is all too much fun for me. I haven't spent the time to model your design, but I think I will and send you the pdf files on it so you got it. I also have an idea for your plates I'll model up for you.

smartHHO
08-19-2008, 09:52 AM
Have you gotten to check what kind of output it is doing yet? Looks real cool design. But cool won't cut it if it does little production. But I do give you an A+ for the design. Looks almost like a airplane engine or something.