hello to all
this is my first post here,but i've been searching around forum for some time now.
my idea of building some kind of hho generator for use in the car is not so new, but since lately i haven't really started doing anything about it.
now i am building a dry cell. i got ss 316L plates from local vendor.plates are not in perfect condition (a lot of scratches,greasy...) so it will take some surface work to make them proper. cell will be 13 plate -nnnnn+nnnnn-. power plates are 160x120mm 2,5mm thick (little to thick i suppose,but want good current conduction over surface). neutrals are same size with one edge 25x25mm cut off and 1mm thick. gaskets are 2mm NBR. 2 outside plates will be 10mm thick plastic (not sure exactly what kind) sized 180x140mm to have 10mm space for 14 6mm holes for screws.
this is what i have constructed so far. now i need to make holes for liquid equalization and gas vent, get some fittings for hoses, water tank and probably a separate bubler with flashback valve (mouse ball type). water tank will also be used as the first bubler. maybe some additional flashback arrestor will be after the second bubler.
i intend to use it in my 1.8L toyota celica, so i am aming for cca. 1LPM at around 20 amps, which will be controlled with PWM (zero fuel type)
will post any update as project proceeds.
any comments and suggestions are more than welcome