The Honda car does not seem to accept the addition of HHO gas !!!

Quote:

---

Originally Posted by koya1893

IRENE has damage much of my house/shop. However, you need to start your EFIE at 9 0 clock and 250mv for the rear, re-set ECU run for two tank full, re-set and run on the same setting and then calculated MPG. Make sure you are feeding it at leasr 1 LPM.

---

Hi,

I made ​​the recommended changes.
I think that 1 LPM is a lot but is worth a try

thanks
Remi

How many amps r u pulling to get 1 LPM? If it's close to 20 then that's way too many amps for that motor. Hondas dont have a lot of low-end torque compared to other cars. Also, if you have a distributor, you could try moving it counter-clockwise to set the base timing with a timing light. Yes this is the base timing adjustment not dynamic. 16-18 BTDC is normal so try either 14-16 or 19-20 and see which works better.

Hi

I have worked that vehicle a few times. I generaly get great gains with o2 spacers and a map enhancer. Since you have the o2 sensor EFIE try it with the map enhancer.

Tune your map sensor about 15% down and you should be up to 35 miles per galon.

Also increase your hho production to about 1lpm+

I have archived 46mpg in one of those vehicles

Quote:

---

Originally Posted by francodrr

Hi

I have worked that vehicle a few times. I generaly get great gains with o2 spacers and a map enhancer. Since you have the o2 sensor EFIE try it with the map enhancer.

Tune your map sensor about 15% down and you should be up to 35 miles per galon.

Also increase your hho production to about 1lpm+

I have archived 46mpg in one of those vehicles

---

Thanks you

Very very good result with new setup (LESS FOR MORE :p)

100km highway, strongs winds, -3°C, approx. only 0.3 LPM HHO and NO EFIE ==> 48 MPG

100km highway, no wind, -17°C, approx. only 0.3 LPM HHO and NO EFIE ==> 40 MPG

Quebecker, just wondering how many amps your running to get the 0.3LPM?

Thanks!

Quote:

---

Originally Posted by bernanke

Quebecker, just wondering how many amps your running to get the 0.3LPM?

Thanks!

---

Approx. 4 amps

Quote:

---

Originally Posted by Quebecker

Approx. 4 amps

---

Quebecker

How is it going in your works, anything help with your HCS idea?