Learning is only possible with mistakes!!!
Thanks for that!!! I will start with 6 neutrals and see how it goes!! Here is something you might help me understand? I see all these hho flow meters (upright tube with water and a 1.5ltr bottle) being used to test output from cells but doesnt the gas produce lift of the bottle without actually filling it as hydrogen creats boyancy????
Built it but it sucks coz I mucked up!!!!
I built my first dry cell -nnnnnn+nnnnnn- 2mmx200x200 316ss with 3mm butyl/epdm high temp gaskets 10mm seal width and 20mm acrylic end plates held with 20 m6 threaded bar,all peachy so far but I decided not to cross sand my plates to see if I could get enough output without compromising the life of the unit but it didnt work for 2 reasons which I think was worth the leason!! The first was I couldnt draw more than 4.5amps continious and 7amps on start up and the second was that the plates bronzed over(surface coating, bronze colour)due to the smooth surface...I am going to cross sand(4 directions) and probably change to -nnnnn+nnnnn-nnnnn+ 3 cell setup. By the way the cell never changed the water temp even though I ran it for 4hrs (probably coz it only ran at 4.5amps,lol) and it only made .5ltr Hydroxy per min. I will learn from my errors and battle on until I am at one with my hydroxy generator and have no problem letting everyone know my mistakes as thats how we learn!!!