Hi,
I made the recommended changes.
I think that 1 LPM is a lot but is worth a try
thanks
Remi
How many amps r u pulling to get 1 LPM? If it's close to 20 then that's way too many amps for that motor. Hondas dont have a lot of low-end torque compared to other cars. Also, if you have a distributor, you could try moving it counter-clockwise to set the base timing with a timing light. Yes this is the base timing adjustment not dynamic. 16-18 BTDC is normal so try either 14-16 or 19-20 and see which works better.
Hi
I have worked that vehicle a few times. I generaly get great gains with o2 spacers and a map enhancer. Since you have the o2 sensor EFIE try it with the map enhancer.
Tune your map sensor about 15% down and you should be up to 35 miles per galon.
Also increase your hho production to about 1lpm+
I have archived 46mpg in one of those vehicles
Very very good result with new setup (LESS FOR MORE :p)
100km highway, strongs winds, -3°C, approx. only 0.3 LPM HHO and NO EFIE ==> 48 MPG
100km highway, no wind, -17°C, approx. only 0.3 LPM HHO and NO EFIE ==> 40 MPG
Quebecker, just wondering how many amps your running to get the 0.3LPM?
Thanks!