That is what I was thinking of building myself. That way I would not need a check valve.
Type: Posts; User: crewdog
That is what I was thinking of building myself. That way I would not need a check valve.
All 1996 and newer OBD2 vehicles can be reprogramed through the DCL port. You just have to find the hardware to do the reprograning. Some options cost more and some are more complex but if it is 1996...
I don't know for sure but you should talk to Mike at, http://www.fleettuning.com/ From the little I have talked to him I would bet he could help. I'm a shop supervisor for a government fleet of about...
I looked to see what was offered for my truck as far as alternators go, it was as high as 200 amp. Which I think will drive my cell OK for the 45 to 50 amps that I'm shooting for, but I think down...
I understand that there will still be current leakage but how much? Will it be anywhere near what I have in my dry cell that has 3/8 holes in all the plates now. I have been an auto mechanic sinse...
I was wondering if, to help stop the stray voltage, we put like a REAL SMALL hole in the bottom of the plates to refill our cells, With the big cell and no stray voltage our cell stays cool, So we...
I went to a class on fuel trim for obd2 [1996 and newer] vehicles and learned a lot. The rear O2 sensors [after the cats] have more to do with how much fuel is injected than I thought. They can...
Ford does use the hot wire sensor. I have over 30 years of working on Fords.
crewdog
You are spot on with this write up. To try to combat this I ordered a DiabloSport Predator because you can adjust fuel, timing, trans shift points, shift pressure, converter lock up, MAF curve and a...
That's impressive a shot glass in 20. I am waiting to see what you can with that.
All modern cars have SS exhaust systems because of the catalytic converter. The converter makes some acid that would rust out your exhaust in little time.
crewdog
Hi Russ,
I read about this to and wanted to try it but taking my cell out of my truck is a pain in the you know what. I have to take the front end off to remove it. If this works for you I am...
All most all newer vehicles will advance the timing that much to help fuel mileage. Under light throttle or decel ignition timing is advanced because NOX emissions wont be that high so to to help...
Good info maybe I should just see how much NaOH it will take to keep it from freezing. Maybe I will add the 5th neutral plate back in and just up my NaOH to keep it from freezing for the winter. When...
On the unit I have now is a 25 plate dry cell 6x6 usable area. I started with 40 mil gaskets and did not think there was enough room to get the water between the plates. So I got some .125 thick...
I agree, If your engine has low compression it will not run lean enough to hurt the engine. If you do have high compression then you could run lean enough to do damage to your engine but with a newer...
Changing the jet will give the best results you must lean out the main jets and the idle. The best results would be to change the main jets buy 2 to 4 numbers. Jets can be hard to find for stock cabs...
Well I was just working off O2's that work with 0 to 1 volt. When I have monitored working O2's they were switching from .4 to .8 volts most of the time. So my thoughts would be to raise the lower...
Just one more thought if the O2's work from 2.5 to 3.5 volts. Over 3.0 volts would be rich under 3.0 would be lean. So would you not need over this to help? Like 2.95. Just another thought! 2.65 just...
Sorry I don't remember seeing that in your posts. I just thought that was what was fighting you with the EGO's. I have seen where the post cat O2's do have some control of fuel. I hope you find what...
Hi Painless,
I have read all 50 pages of this post. I am a certified master mechanic with over 40 years on the job. I'm new to HHO Just built a 25 plate dry cell with 6x6 plates. On your work with...