Its very simple they are using only 1 positive and 1 negative
and the rest of the plates are all NEUTRALS
Example: +NNNNN....-
you need to have about 2v per gap
so at 120volts youll need about...
Type: Posts; User: NightOfDarkness
Its very simple they are using only 1 positive and 1 negative
and the rest of the plates are all NEUTRALS
Example: +NNNNN....-
you need to have about 2v per gap
so at 120volts youll need about...
Yes there is 308 and 309 and 310 etc...
http://www.engineeringtoolbox.com/identification-stainless-steel-d_383.html
I believe you could tell the difference after you run your cell if its 316L your water will stay clean/clear anything less will turn your water brown. Youll know after you run your cell for few hours...
for RSX
AEM EMS ENGINE MANAGEMENT SYSTEM ECU 02-04 ACURA RSX
AEM's Plug & Play Engine Management System (EMS) are for racing vehicles and plug directly into a vehicle's factory ECU harness and...
You dont need EFEI, soft avaliable FREE works with laptop connect to your ECU and adjust air/fule ratio LIVE - refering to integra with obd1 ecu if you have an RSX the equipment is too expensive to...
purchase a OBD2 to OBD1 Convertion cable and a OBD1 MODDED ECU or USED ECU and a Chip for $10 and do it yourself, soft avaliable for free to adjust your air/fule ratio
I would say any tunner car like Honda/Acura with OBD1 setup Chips are sold everywhere for as low as $10 and software works with laptop is free just google it "SPOON CHIPS ECU INTEGRA" etc...
You...
Purchase a OBD1 ECU for your Integra on ebay "OBD2 to OBD1" and a Modded OBD1 ECU with a Chip that you can custom tune the fule ratio etc...
you wont see any results as the ECU has set amount of...
Purchase a OBD1 ECU for your Integra on ebay "OBD2 to OBD1" and a Modded OBD1 ECU with a Chip that you can custom tune the fule ratio etc...
you wont see any results as the ECU has set amount of...
0.6mm = 22 gauge
0.7mm = 21 gauge
0.8mm = 20 gauge <-- our's
0.9mm = 19 gauge
1.0mm = 18 gauge.
Well it's never to late to invest $160
Besides, the word tried, was it completed? I think it will cost you lot more than $160 to make it yourself.
buy one and test it yourself i am not saying anything, different measurements coming from different people.
That was an example
The usual 0.8mm = to 19guage
yes, not yet posted it, soon though
check back next week
site is in the making
we have bubblers for $30 shipped
www.gidragen.com
Please check our website at www.gidragen.com
We can supply you with as many DryCells as you want $160 for 21 plate 316L 100% 6x6
if you order Qty. price will drop down to $120 each check...