"Decide to install HHO system. Spend 2 years researching and gathering information.
All experiments were done without any EFI/ERIE installations."
...
"Now I think that additional unused...
Type: Posts; User: DUG-KOH
"Decide to install HHO system. Spend 2 years researching and gathering information.
All experiments were done without any EFI/ERIE installations."
...
"Now I think that additional unused...
GHOSTOWLGRID
About your capacitance...
Permittivity of Water:
(relative to free space)
88, 80.1, 55.3, 34.5
(0, 20, 100, 200 °C)
The P-ch FET is driven as a high side switch with a Vgs of >10V.
It goes fully ON and has very little voltage drop to reduce power dissipation.
This is GOOD
The problem with just changing the...
I previously posted the freezing point data here:
http://www.hhoforums.com/showthread.php?t=1598&page=3
This was found from a few "internet sources" and put into one graph
As lhazleton says:...
Greetings
Being from the great white north I have done some research on freezing points
The attachment is what I have discovered.
I only considered KOH vs a couple of alcohols.
I would...
One way to get the signal you need from the injector is to use an opto isolator...that is the easy part.
This would only load the circuit to the tune of 0.010 to 0.015 A...Injector drive would not...
When you select a FET you should look at "Rds on". This is the resistance of the FET when it is fully on (at 25 deg C)
The first one you were using (NTB125N02R) is 0.0037 ohms. Respectable
The...