You need to adjust both pre-cat sensors to get proper results. I don't know if your EFIE can do this. Not all will. Check with the source of your EFIE to find out what you can do.
Type: Posts; User: atfab
You need to adjust both pre-cat sensors to get proper results. I don't know if your EFIE can do this. Not all will. Check with the source of your EFIE to find out what you can do.
Sorry, I have been busy elsewhere.
Batteries are a way to easily provide an isolated voltage source. the idea is to raise the native voltage slightly. If you use a chassis ground, the volts will...
Sorry, I have been busy elsewhere.
Batteries are a way to easily provide an isolated voltage source. the idea is to raise the native voltage slightly. If you use a chassis ground, the volts will...
My local Home Despot carries it and the regular Goop.
You rest the computer by disconnecting the battery, this resets to a default setting, expect many on/off cycles for it to re-learn the system.
Give it a few days or so.
I wouldn't trust Pickens as far as I could throw an an elephant! He has never done a thing that didn't work out in his favor.
Last week he bought control of General Electric, at bargin a bargin...
NFryan,
Two things; first I would be adding in 1/4 TSP doses. I had to do this to sneak up on my cell's cold start amps.
Second, One more neutral plate would help control the heat.
...
dlynds,
You may have posted your own solution, It sounds like the problem is in your fuse or circuit breaker hookup. There may be a poor connection or defective breaker.
Try putting them back...
I guess you still don't understand, My reply to the first poster and you was simple and accurate. Not the technicial hyperbole you just posted yet protest that it is somehow more informative. You...
Sorry hg2, it was a third party that mentioned Meyers. Boyce also has done more with his electronics than simply raise the voltage, so the point still stands.
I am by no means an advocate of the...
Just remember you need a real good bubbler on a carb, the chance of a flashback is much greater.
hg2 and Atm0spher,
Sirs, you are both technically correct, but incomplete.
Obviously the high voltage cell will have a somewhat different design. Meyers did much more than simply raise the...
redneckgearhead34, I didn't find a listing on a "hardbody" but I did find 2.4L pickup
"On your 1994 Nissan/Datsun Truck Pickup 2WD 2.4L SFI , the Mass Air Flow Sensor is located:
Under hood,...
redneckgearhead34, it might not, I suspect you have a single point injector in what looks like a carb, Correct me if I'm wrong. it might have a TPS and that will control the injector. Good luck,...
redneckgearhead34, Try again at 25% restriction. Some times a little is a lot.
I hope this works, if not try my photo site for a simple o2 adder.
atfab
it did!
Still why?
Assume a HHO generator at 13.7v drawing 15a.
To compare it to another one at a different voltage, you need to figure the total power used.
This would be watts. Watts are the...
Nice job Jimbo40, My inlet is vertical and I have some 1/4" plexi, might be too heavy but worth a try. Could always drill some holes.
atfab
Well my 55 mile trip home seemed to go well.
My scanner reads out trims in percents +/-.
Short term fuel trims seemed to be slightly wider in general neg. to pos. But on trailing throttle it...
Well now, I've been lurking at this site and thread for a few days now. It seems to me that restricting the air intake is the same thing many have tried with so-called MAP adjusters.
I have been...
Ridelong, Could you please give some more detail on the probe assembly. A pic or two would make things real clear. Thanks!