Thanks,
I'm running 25-35 amps depending on the engine rpm ..at idle the volts are lower .
I aproximate my reading by blowing up balloons with a stopwatch and doing a volume calculation
I...
Type: Posts; User: nikolatesla
Thanks,
I'm running 25-35 amps depending on the engine rpm ..at idle the volts are lower .
I aproximate my reading by blowing up balloons with a stopwatch and doing a volume calculation
I...
Thanks for that,
I was under the distinct impression that I would see an increase because of the better burn .
Timing will be difficult to tamper with but I will investigate the ways to to do it...
Hi all,
First I want to thank everyone for the kind help here .
I have installed my hho system and run it for 3 tanks of fuel (petrol)
I have found no difference but I will explain the setup...
It this an add??
If so please give all of the details like milage claims and show your test results for us .
my air conditioner has been running in my landcruiser for 200 thousand miles but it...
It may be that the alluminium /stainless contact area will be a problem in the long run.
I dont know if any body has tried it yet. or if not why not . As the conduction, both electrical and heat...
Like this with positive in the middle and negative at each end
No They are not in contact with the solution but are flat against the last cell ss plate at both ends al ss-nnnnn+nnnnn-ss al . There is no way I would use alloy as a cell plate , just a good...
OOPS ,sorry I was not clear at all
I used alluminium for the end clamp plates ,the cell plates are stainless, but and are in contact with the external heavy alluminum on each end allowing quite a...
Good point,
Im using the transmission switch output in the center console mechanically attached to the handle which is 12 v high in drive . I aslo powers the D light on the dashboard . Ill use a...
Thanks biofarmer ,
Ok then my setup will be with it pre air cleaner for a few thousand kilometeres.
If i dont get results I will change it and see ...heck, I will probably change it and see...
Hi again everybody,
I'm at 3rd base with my first system and planning on injecting pre air cleaner.
Im gertting 1 lpm for about 18 amps -nnnnn+nnnnn- 6"x6" plates ,diamond oreintation. cell temp...
Hi all,
I have just got to first base with my first cell .
Im down under and it is going in a 105 4.5 l pertrol landcruiser.
I am using a slotted no holes design that I think is my own.
In the...
Thanks Gentlemen
This might be fun
I like "dry edged fuel burner"
or "skeptik magnet"
even " arrogance tester"
better "ignorange blaster"
how about " recirculating under bonnet fuel...
It is called entertainment it is entertainment and they are very funny sometimes ....please dont expect there to be anything important revealed by these bufoons . Their main source is movie myths...
Hi everyone ,this is my first post and I would like to thank you all for being so helpful as I build my first serious generator.
I am heading down the path of a slotted box design with no plate...