Search:

Ok I'll check my area.
Thanks

Hey Darrell thanks for the advice and video.
I will give that a try also.
I should have a pretty good assortment of gasket materials soon.
Where do you have you 316L sheet laser cut at? Online...

Thanks whear,

If I purchase the 1/8" will that cover all my bases or will at lower LPM production having the plates closer is a better design?

I can order a few different thicknesses for tuning...

koya1893 that sounds great what MPG are you getting out of her?

Fuel Injected or carb setup?

I hope I'll be able to drive the Dart to work soon, it was getting around 12MGP before I put it in...

whear thanks again it looks like I'll be spending a little more money.

As far as the 316L plates I will order the 16ga. as recommended (McMaster-Carr #88885K24).

End Plates Sheet, HDPE, White,...

Thanks again whear I will look into that material.

I was thinking about running 20ga. 316l plates does that sound good or is there a better thickness to run.

The HDPE is for the end plate and...

whear thanks for the reply it does make sense.

I will run a single stack being that it is more efficient with 7 plate stack 5 neutrals 6"x12".

The reason for the larger design is that I have a...

Hi everyone,
I'm extremely new to this forum and HHO in general. I’m interested in building a dry cell.

Would a 12”x12” with 11”x11” exposed plate surface be a better than two cell’s that are...