Search:

I thought I would break down and buy a reservoir but almost all the ones I find have the cell gas port below the fluid level. Top port gas to bubbler, bottom port to bottom port on Dry Cell. Third...

I agree with you about the back pressure. HHO Cells don't like back pressure at least in the 1-3L/min range. I avoid even using 90 degree fittings. on the output and minimum 3/8" tubing. I just got...

My latest efforts are with a 4.6L V-6 and I am producing around 2 liters/min and I just got back from a 1k mile trip. On the way out I pushed the EFIE and MAF to the point I noticed performance drop...

You are brave planning to modify such a new vehicle.
There are some dangers in using EFIE and MAP/MAF devices. First of all can you generate enough HHO? The rule of thumb is 1Liter/Min per Liter of...

Keep in mind if you are measuring the voltage with a meter you will get the average. The voltage is actually getting switched on and off with the PWM.
When it is on the voltage is higher. If you...

If you add a general purpose diode to the battery circuit it will regulate the battery output and extend the life indefinitely. At least way longer than your car. For those electronic savy folks the...

Every FET (the electronic switch in a PWM) has an ON resistance RDSON. The voltage drop will therefore depend on current flowing but I guarantee there is a voltage drop across it even when no...

The one thing I would be concerned about is starting to get a voltage drop across the plate. I believe the reason we are limited to 6" x 6" cells is because going beyond that the voltage would drop...

I wanted to close the book on this thread even if no one reads it.
I reordered my plates and fell for the temptation to make two changes at once. I made a small manifold tube aka Smack/Jdmusician...

I think I found my problem. I put the plates together in the wrong order. I have five Neutrals in the first group and three in the last.
I made a little manifold insert out of a pen tube that fit...

I have learned a bit from Scarecrow and the gang over at EBN

energybuildersnetwork

Gaskets are .06" rubber. they compress fairly easy. I have tightened on the bolts and not seen much affects on gas flow. Looking closer at my reservoir I notice a combination of what Scarecrow calls...

Thanks for the idea. I plan to put a tube to block two of the top holes.
I have read plastic coat does not hold up with time. I used 3M Marine on my wet cell. Just buy the fast drying kind. Waiting...

I have taken a step backwards. I made a 13Plate Wet cell that works pretty well. I get close to 5MMW at 1L/min with very little leakage due to glueing acrylic plates to the sides and bottom.
I...