Search:

Type: Posts; User: DUG-KOH

Search: Search took 0.00 seconds; generated 41 minute(s) ago.

  1. Replies
    5
    Views
    29,476

    "Decide to install HHO system. Spend 2 years...

    "Decide to install HHO system. Spend 2 years researching and gathering information.

    All experiments were done without any EFI/ERIE installations."

    ...

    "Now I think that additional unused...
  2. Replies
    4
    Views
    11,195

    GHOSTOWLGRID About your capacitance... ...

    GHOSTOWLGRID

    About your capacitance...

    Permittivity of Water:
    (relative to free space)

    88, 80.1, 55.3, 34.5
    (0, 20, 100, 200 °C)
  3. Replies
    9
    Views
    34,503

    The P-ch FET is driven as a high side switch with...

    The P-ch FET is driven as a high side switch with a Vgs of >10V.
    It goes fully ON and has very little voltage drop to reduce power dissipation.

    This is GOOD

    The problem with just changing the...
  4. Replies
    8
    Views
    23,246

    I previously posted the freezing point data here:...

    I previously posted the freezing point data here:

    http://www.hhoforums.com/showthread.php?t=1598&page=3

    This was found from a few "internet sources" and put into one graph

    As lhazleton says:...
  5. Replies
    26
    Views
    38,594

    freezing points

    Greetings

    Being from the great white north I have done some research on freezing points

    The attachment is what I have discovered.

    I only considered KOH vs a couple of alcohols.

    I would...
  6. One way to get the signal you need from the...

    One way to get the signal you need from the injector is to use an opto isolator...that is the easy part.

    This would only load the circuit to the tune of 0.010 to 0.015 A...Injector drive would not...
  7. Replies
    8
    Views
    17,625

    When you select a FET you should look at "Rds...

    When you select a FET you should look at "Rds on". This is the resistance of the FET when it is fully on (at 25 deg C)
    The first one you were using (NTB125N02R) is 0.0037 ohms. Respectable
    The...
Results 1 to 7 of 7