Search:

Type: Posts; User: satish

Search: Search took 0.00 seconds.

  1. Replies
    8
    Views
    9,678

    After testing output late afternoon today i had...

    After testing output late afternoon today i had all the wires,plug cables, battery, distributor, ignition coil etc in the engine bay removed to spray cleaner fluid because i dint want the degreaser...
  2. Replies
    8
    Views
    9,678

    I checked the alternator output under no load at...

    I checked the alternator output under no load at 1800 to 2000 rpm its 13.8 to 14 volts and just close to 50 amps. At around1000 rpm its 13.2 volts and 38 to 40 amps. With headlights at low beam,...
  3. Replies
    8
    Views
    9,678

    THANK YOU for considering my question...

    THANK YOU for considering my question ultra_efficient.
    My car alternator produces its highest at 13.8 volts at 46 amps. I have no knowledge of the output at different engine speed or at idling. I am...
  4. Replies
    8
    Views
    9,678

    Update The epoxy i had to seal the plate hole...

    Update
    The epoxy i had to seal the plate hole edge did not hold good during passivation with vinegar. Got to find something better.
  5. Replies
    8
    Views
    9,678

    Gentlemen as of now i have done some little...

    Gentlemen as of now i have done some little improvements in my setup. A vaccum relief valve as not to suck when the reactor is cold/off after certain period of running. A aquarium 1/2 inch air stone...
  6. couple of questions before final installation / IS IT TRUE ?

    Hello gentlemen
    I want to know how much hho can i generate from a +nnnnnn- 5× 3 active area dry cell, considering the .5 amp per square inch theory ie 7.5 amps.? For any detailes on my setup see...
  7. Replies
    8
    Views
    9,678

    gentlemen. Can i use RTV sillicon gasket maker or...

    gentlemen. Can i use RTV sillicon gasket maker or araldite epoxy adhesive or the likes instead of weldon. WOULD IT SERVE THE PURPOSE? For reducing current leakage and improve efficiency..
    And My dry...
  8. Replies
    8
    Views
    9,678

    plate configuration for suzuki cultus 1.3

    Hello gentlemen
    Iam satish from india, i recently developed an interest in tweaks for better mileage. Now addicted to hho from not so long ago. Im about to try it on my suzuki cultus 4 door 1.3L 96...
  9. Thats coz hho is not plug and play and requires a...

    Thats coz hho is not plug and play and requires a certain level of involvement with the car. You may call it trail and error or finding the sweet spot. And not eberybody who buys a car has this...
  10. Replies
    3
    Views
    6,801

    Good going. Best of luck for a new revolution....

    Good going. Best of luck for a new revolution. For now im speculating about fitting my cell in the trunk/ boot as my car is small with a little engine.
  11. Replies
    3
    Views
    6,801

    Hi kyle. Im satish. New too. Welcome to the...

    Hi kyle. Im satish. New too. Welcome to the forum. Im in the process of installing a dry 11 plate cell in my car. What about you?
Results 1 to 11 of 11