Gottcha.
The bubbler is about a foot long out of 1.5" PVC with a plastic tube on the outside to monitor liquid level. I have been returning the electrolyte back to the cell when the level is...
Type: Posts; User: MtnGoatXJ
Gottcha.
The bubbler is about a foot long out of 1.5" PVC with a plastic tube on the outside to monitor liquid level. I have been returning the electrolyte back to the cell when the level is...
Seems that the generator really sends a lot of moisture into the intake.
So much so that the throttle plate is eroding away.
I spent an hour cleaning off the accumulated CAa-Caa in the throttle...
Good news is that your system appears to be working correctly if the MPG has dropped. The O2 sensor is "seeing" a lean condition and compensating by adding extra fuel. Have your elec eng friend...
Most of my driving is stop & go. Been nursing the throttle for years to get 15MPG on pump gas. Been monitoring the AFR guage for that long as well. So making any setting changes on the EFIE is done...
I found a very reasonably priced ($80) narrow band AFR by "Koso". I'm guessing they were discontinuing the product. A two wire O2 sensor (my spare off the shelf) was located a few inches down stream...
With all those bubbles, one can clearly see with our calibrated eye, thats almost 4 lpm for sure!
:D
My thought process is, well, scarey if you want to know the truth....
So using the AFR (stand alone O2 sensor) to monitor AFR under normal driving conditions. Then switch on the gas and using the...
Well I did something!
MPG went down. Believe it or not, this is GOOD!
Thanks to all.
Ok so adding al dust or acid to a bubbler will not reduce electrolyte vapors from eating the throttle body/butterfly.
What is a recommended design for a mechanical dehumidifier?
Scotch Brite in a...
I was given this recipe 860ml of distilled water and 140gr (5oz) of KOH on this board.
Thats roughly 25oz to a gallon of DS.
That's what I needed guys.
Again, many thanks for your time!
http://i.imgur.com/WXo6Z.gif
No, very course sand paper will.
Like 80 or 40 grit
Currently my voltmeter is across the battery.
would it be best to measure voltage across the reactor instead?
http://carphotos.cardomain.com/ride_images/1/2192/3369/5479184028_large.jpg
OK
The plates have been blasted and passivated.
Still have the 6N5N6N configuration but this is not the final config.
Removed the PWM from the circuit.
Added flake KOH until I was indicating 15...
Check valves in the gas output lines?
No worries. Not the first time I was told my juice was weak....:rolleyes:
Gotta read more too!
Bio,
Many thanks for your replies and knowledge share.
Half strength solution formula has me perplexed. At first I thought it might be a typo.......860ml = 0.2 gals?
My mixes to date to make...
OK those plates were smooth and shiney, no wonder..........
I've bead blasted the plates and reconfigured to -NNNNNN+NNNNN-NNNNNN+
The odd center is due to hardware limitations.
Here's the...
Any suggestions or experiences are read, reread and believe me when I say, graciously accepted. I read through a number of forums before embarking on this adventure to gain knowledge on others...
6" 25 plate ||-NNN+NNN-NNN+NNN-NNN+NNN-|| 1070 Sq Inches
fleabay item # 330524382127
My first attempt to keep everything under the hood
...
Humor, I like. :D
I hope all can see that this is a well thought out and constructed project.
My efforts may be better spent on a different engine. But the Cherokee and 4WD work well as my...
Power monitoring top cover
http://carphotos.cardomain.com/ride_images/1/2192/3369/5479184018_large.jpg
Final test on the bench
...
As indicated by other Jeep owners I had to setup the dry cell in the cargo compartment.
There is just no room under the hood.
Unit container (Stanley 2 Compartment Tool Box)
Oops, sideways........
I've been experimenting with HHO units for about two years now with little success.
Vehicle 1992 Jeep Cherokee 4.0L I-6 automatic.
Anyone have time with this engine?
My DD service vehicle...
Thats great
I've been experimenting with HHO on my 92 4.o without any success.
Sounds like your system really works well.
Any pics?