I have changed my plate setup as following
1. Obtained 316L plates (size 2” x 6”)
2. Config. ‘+ N N N N – N N N N +’ with 1/16 gap
3. Added check valve to stop backflow of water from Bubbler
4. Checked for leaks using soap water and sealed
Results:
I am observing only ½ LPM;
I am not quite happy with the result I do not know else to do to improve gas production. I need minimum 1 LPM to start with.
Please check pictures and comment:
http://picasaweb.google.com/tbhavsar...ith316LPlates#
Increase your electrolyte solution untill your satisfied with amps/LPM
1995 Chevy Camaro
17 MPG base city/highway
Listening to Van Halen