Made my own MAP Enhancer - pics
Made my own MAP Enhancer - pics
Come to the Darkside - We have Cookies
And lots of KOH (16 LBS)
Not currently running HHO.
I dont run HHO during winter.
Looks good. Where did you get the knobs and housing? Total cost in the end?
Knobs were just lying around, and box come from the Source - as posted before - http://www.hhoforums.com/showthread.php?t=1471
and totla cost before i order better knobs is $9.00, only because box was cheeeeaaap.
Come to the Darkside - We have Cookies
And lots of KOH (16 LBS)
Not currently running HHO.
I dont run HHO during winter.
havnt tried it yet, and have schematic on paper only (and will not give out until knows it works). Only took 1 hour to assemble (first one always takes longer) after getting supplies.
will install tomorrow.
and is way to hard to find a schematic online.
as u can see it has an ON/OFF switch and CITY/HIGHWAY mode.
and ordered gold plated / aloy knobs - $2.00 each!
Come to the Darkside - We have Cookies
And lots of KOH (16 LBS)
Not currently running HHO.
I dont run HHO during winter.
Theres a schematic around here somewhere. Search enchancer and you should find it.
Come to the Darkside - We have Cookies
And lots of KOH (16 LBS)
Not currently running HHO.
I dont run HHO during winter.
So i was doing more reading and testing of mine(without mod) on map sensors, and found that the map read just a smidge over 2V at idle. And on full acceleration was near 4.6V.
didn't install yet -just testing regular drive volts along with acceleration.
does anybody know the voltage when the computer goes to open loop??
Come to the Darkside - We have Cookies
And lots of KOH (16 LBS)
Not currently running HHO.
I dont run HHO during winter.
Would any one know why that schematic show a 50k resistor on a single pot. and a 33k on a double pot.