Page 1 of 2 12 LastLast
Results 1 to 10 of 18

Thread: something very interesting

  1. #1

    something very interesting

    found this in my travels ( hxxp://www.skyhero.com/) change the xx to tt..... now here is a guy just using a plasma spark to increase his gas mileage , wierd set up but according to him it works. he has videos on the site and a download of the schematic .

    comments welcome .....
    Pro

    Oh and I would like to offer a open invitation to my site were new...in town ... to the boys here... see sig if you come over you will see that your site is listed in links ..I figure the more the better it is for all
    HHOinventions.com

  2. #2
    fisher Guest
    Is this valid, or are you doing some of that "free advertsing"?

  3. #3
    no its valid and i think all sites should work together
    HHOinventions.com

  4. #4
    Join Date
    Jul 2008
    Location
    North Jersey
    Posts
    221
    Mother????????

  5. #5
    Join Date
    Aug 2008
    Location
    Dallas, TX
    Posts
    490
    Sir Spam-A-Lot?

  6. #6
    theramsey3 Guest
    I think that this is very possible, makes sense and a great idea but needs some refining it would create a much hotter spark which would theoretically ignite a fuel charge much faster in turn causing a more complete burn which would increase fuel mileage. I think you could introduce the 120vdc in either polarity because you are only using your primary coil spark to create a bridge for it to travel across. I will try this as soon as i can buy a power inverter and a four diodes and a potentiometer that will handle about 600 to 1800 watts (light dimmer switch for 120v incandescent bulbs) being that it isn't drawing very much amperage for each amp of power you draw at 120v you are only drawing 120 watts so 5 amps would be 600 watts and 15 amps would be 1800 watts and the whole point of his microwave transformer is to lower the voltage in the circuit under a load. In the video he was using a small fuse I can't remember what it was but I'm pretty sure it was about 5 amps which is where I will try to start with mine and then step down to smaller fuses until i blow one. Any more ideas would be welcomed. sorry I got so long winded.

  7. #7
    Join Date
    Jul 2008
    Location
    North Jersey
    Posts
    221
    My mother reply was to bust chops on the guy that said mother and dad. It was just stupid guy banter. I wasn't raised in a very proper home and always called my mother (yea I have one too) mom. The vid was awsome and should be looked into more

  8. #8
    theramsey3 Guest
    Quote Originally Posted by Shane Jackson View Post
    What?? I an not following you guys. I have watched the videos and find them very interesting. He said that he can run the engine on water but it runs like crap. I think he needs to add HHO and maybe ethanol if the HHO is not enough.
    you supply the cathode and anode ( positive and ground) on the spark plug with a low voltage high amperage (120vdc) power supply that can't jump the gap by itself but when the low amperage high voltage coil provides a spark the 120vdc can then make the jump across the gap

  9. #9
    Join Date
    Aug 2008
    Location
    Dallas, TX
    Posts
    490
    Funny that I am explaining my post, but anyway... The hxxp://.. thing is a bit of a weird way to try not to be viewed as spam (if that's actually the intention). Just found it very interesting.

  10. #10
    Join Date
    Jul 2008
    Location
    North Jersey
    Posts
    221
    Theramsey3, Your post wasn't long winded at all. Well composed and well said. I just wish I understood what you said. I'm a cabinet maker / builder not an electrical engineer. The consept of a hotter spark seems good but if you introduce HHO the burn will be faster and more complete so won't the timing need to be retarded.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •