thanks for reply
I have two drycells, one have nn-n+n-nn and is 6x6 inch, the other one is 4.5x4.5 and has n-n+n-n+n-n+n-n.
For some reason volts dropws down after while, I think because the cell gets worm or smth.
I tryed to run both those cells paralel to get more hho into the generator, but same results.
If I put more baking soda into the water, the volts drops down too.
So i tryed to run 15 v as long as I could, and tryed to run 6-7 volts after, production was pretty much the same.
Generator is diesel fuel super quiet one, made in china (of course, where else, everything is made there, mabe thats the problem
) )
5500 w.
Also have 3kw load on it (two 1.5kw heaters).
Gas tank is off, got plastic tube atached to fuel line, to be acurate on fuel quantity.
have a needle on the back of the hose, where hho comes out, so the gas would go even, and be injected.
The needle is deep as it can go, pretty much wright above the valve.
suction in air intake is good.No leaks in the system, checking it everytime.
Always running 20A on the cell, also tryed useing water pump to run electrolyte, or no pump.
cells never got hot, just worm.
Tryed to block the incoming air to air intake, just got worse results, tryed no filter, no results at all, filter on(poked the hole in air filter to get the hose in there, and kept it in fixed position) got 8% better time.
mm, can't think of nothing else i did, but thats about all I can think of doing to this generator, out of ideas
so...what could help to get better time?