Thermostat Dry Cell Reservoir Idea

[BoyntonStu]

Wishing to run my Amoeba Cell dry for efficiency, I thought of this possibility.

Connect a normally closed 12 VDCsolenoid valve in the input line.

Attach a thermostat on the cell to control the valve.

Start up the cell.

When the temperature climbs to let's say, 140*F, the solenoid fires and the in rushing electrolyte cools the cell.


When the cell cools to the lower open thermostat point, let's say 130*F, the solenoid is cut off and the cell goes dry again.

Comments?

BoyntonStu

[Q-Hack!]

Interesting... May want to think about fail safe though. What happens when your solenoid sticks in the closed position and temps continue to climb. I suppose that at some point the cell would be dry and no current would flow at all... but would your cell self destruct before that point?

[BoyntonStu]

Interesting... May want to think about fail safe though. What happens when your solenoid sticks in the closed position and temps continue to climb. I suppose that at some point the cell would be dry and no current would flow at all... but would your cell self destruct before that point?

Dry cells don't conduct.

If the solenoid fails, the Ammeter will show a decrease in current as the electrolyte level decreases.

I have started up my Amoeba Cell completely dry with no difficulty.

I do not believe that adding a solenoid valve would be dangerous.

BoyntonStu

[cully]

interesting idea!

be careful with the seals and the body meterial on the solenoid valve the will need to be compatible with the electrolyte

[hg2]

Stu here's a link for a stainless 12v solenoid valve that may be compatible with e-lyte solutions.Seems reasonably priced and thermostats are easy and inexpensive to obtain also(sorry I don't have a link for those).


http://www.kingssupply.com/item137.htm

[Michaeljp86]

What about using a thermostat from a car? Then you wouldnt have to worry about powering it. The electrolyte may rust it up.