My tests and pics and etc

[mytoyotasucks]

So whats your MPG with no cell now?

On my 83 Deville, I get around 23 MPG(Canadian)

[mytoyotasucks]

pic of my dry cell gaskets

[mytoyotasucks]

ok next dry cell test

13 plates +NNNNN-NNNNN+

.082 gap

10% KOH by weight

15 amps cold 13V

results to come.

[mytoyotasucks]

ok next dry cell test

13 plates +NNNNN-NNNNN+

.074 gap

10% KOH by weight

15 amps cold 11.4V


500ml - 40 sec

mmw - 4.39

Theoretical Volume produced
by 100% Faraday Efficiency - 690 Milliliters

Your percentage of
Faraday Efficiency - 72.4%

a slightly smaller plate gap made a big difference. from .082 to .074 doubled the out put and temp came down.

proves testing is required per unit, to find out gap needed for that unit type.

[mytoyotasucks]

This is the last cell and configuation i have used and will continue to use.
It is a wet cell (find it more reliable) with titanium plates(23 plates in a 3 cell ), producing about 4.5 LPM at 25 - 28 amps.
I use a air compressor dryer(aprox $15) to filter out steam and water.
I use a map sensor enhancer and an EFIE to control sensors.
My average milage gain is 18 - 22%.
I use a laptop or tablet to monitor the different sensors, so i dont overheat or lean out and harm the motor.
Pic included.

[hhofox]

Hi,
Just wondering, where are your bubblers in relation to the dryer?

[mytoyotasucks]

Hi,
Just wondering, where are your bubblers in relation to the dryer?

I dont use bubblers.

[hhofox]

OH, no bubbler?!
Why not?
How does that work out for the NaOH or KOH fumes entering your engine?
Please enlighten me.

[mytoyotasucks]

I use an air dryer that takes any water or wetness out.
I find it works good.