UPDATE: Someone has ask me to restore all the images as the host site was no longer hosting the images...
The cell is made up of 36 - 316L stainless steel plates measuring 8"x8" with neoprene gaskets between each plate. This is a 7 cell design. I will be using a custom 80 amp PWM and a DEIFE to control my O2 sensor. Also the system will be wired through a oil pressure switch, doing so makes the entire system safer to operate due to the engine needed to be running for the cell to operate.The cell block is configured as follows, -nnnn+nnnn-nnnn+nnnn-nnnn+nnnn-nnnn+
You will see in the drawing I am using two bubblers with Vinegar in the last bubbler to clean the HHO gas before entering the intake.