My Dry Cell Project

[DodgeViper]

UPDATE: Someone has ask me to restore all the images as the host site was no longer hosting the images...

The cell is made up of 36 - 316L stainless steel plates measuring 8"x8" with neoprene gaskets between each plate. This is a 7 cell design. I will be using a custom 80 amp PWM and a DEIFE to control my O2 sensor. Also the system will be wired through a oil pressure switch, doing so makes the entire system safer to operate due to the engine needed to be running for the cell to operate.The cell block is configured as follows, -nnnn+nnnn-nnnn+nnnn-nnnn+nnnn-nnnn+

You will see in the drawing I am using two bubblers with Vinegar in the last bubbler to clean the HHO gas before entering the intake.

[DodgeViper]

[DodgeViper]

As you can see everything will be neatly behind the front bumper with the last bubbler inside the hood mounted on the firewall. The final bubbler will have a sarran wrap blow plug as well. The final assembly will be made once I have the entire bracket made and it has been powered coated. I have yet to decide where the PWM will mount but it needs to be under the hood and so that I can make adjustments to the pots.

[DodgeViper]

[DodgeViper]

Here are photos of the cell mounted. I took a piece of ¾” PCV flat stock, cut it to the width of the inside of the end plates. Next I machined out a 3” wide grove and ½” deep so the cell rest over the cross member I built and installed. Next I bought a product called “Make Your Own Hose Clamp. This material comes in lengths up to 50’ if needed. Using the stainless steel hose clamps I clamp the cell to the cross member. It’s a very ridged mount and the cell will not move.

Thought I would share a photo I received from the maker of my cell. This is how you remove all finger prints, dust, etc. before building the cell. Also take not that the plates are NOT sanded as some are doing to their cell plates. There is no solid proof that I have read that says sanding the plates helps HHO production... I think what’s going on is there is a lot of BACK YARD mechanic work going on and being reported with no proof to back it up…

[DodgeViper]

[DodgeViper]

I have been asked to repost all the photos as the host is no longer hosting the photos.