saturation point of NAOH

[PeteVamped]

You bring up a really good point I may have to take some time away from all my other work to figure this out even if it is just for my self.

[Q-Hack!]

A resistive curve would be helpful to a point. Remember that resistance will change with temperature, so take a temperature reading when you create your curve. In fact I would suggest that you do two curves, one at 70 F and another at 110 F. (21 C and 43 C respectively)

That way you will be able to calculate what your current draw will be at start and after the cell warms up.

Of course if you are using a PWM then the second is not as important.

[PeteVamped]

A resistive curve would be helpful to a point. Remember that resistance will change with temperature, so take a temperature reading when you create your curve. In fact I would suggest that you do two curves, one at 70 F and another at 110 F. (21 C and 43 C respectively)

That way you will be able to calculate what your current draw will be at start and after the cell warms up.

Of course if you are using a PWM then the second is not as important.

your a genious there q-hack thanks for sharing your info