i am now going to use this thread as my main discussion board. all my comments, concerns and questions will be posted here
1. a lot of people are using 316 stainless plates. I have access to sheets of 321 stainless (from what I know the only dif. is the heat treating process). The only thing is no one addresses the thickness of the plates.
2. I have been kicking around the idea of getting a cell from http://www.socal-fuelfromh2o.com/hhogenerators.php from what I understand from them along with some others is since I have a '94 full size Blazer and I should not have issues with my O2 sensor. These problems are accruing in vehicles 96 and newer.
3. The cell from fuelfromh20 is 5.625x5.625 x 3.5 so I am assuming the plates they are using are about 5x5. Does the size of the plate and the thickness make a big difference? I assume the bigger the plates are the less number of plates you need.
4. There have been many posts about the way to wire the cell and the number of n plates between the + and - plates. But there are some people that use no n plates and alternate the + and - plates. Have any of you tried this? And if so what where the results.
5. I have a 5.7L TBI, what would the best output from the cell be for an engine this size?