Hi, new here but have read alot about hho. I have an 11 plate dry cell and a 30amp pwm purchased on ebay. The thing I'm trying to figure out is that when the cell is powered up has 13.8v engine running. And the amp gauge and fluke meter hooked up says it is drawing like 10amps. Now when I turn the dial clockwise(increasing the amps)it will actually lower the amps. Like down to 3amps??? But my production of hho gas increases. Weird. I have checked all the wiring and all is good. I noticed that as I increase(or turn up the dial)that looking into my dry cell a lot of bubbles are happening and the water level lowers below half of the cell. Any thoughts on this? the cell is configured
-nnnn+nnnn- 11 plate/316L and has a gallon feeder above it. thanks dave