Originally Posted by
dg2010
I am trying to sort out some gasket material for a cell and am thinking about using 3mm nitrile sheet. Could someone please let me know the best way to cut this.
I was thinking of using a wide sharp blade - something like a hand planer blade and hitting with a hammer to punch through. Never having seen the material I was wondering if there would be too much bounce back and not enough to penetrate the material.
Thanks
A box cutter knife works great.
Larry
2008 Nissan Frontier 4X4 Nismo. 12 MPG baseline with my normal commute and heavy stop and go daily driving. Generator installed and working on 3/29/2009
Up to 14.5 MPG with no enhancers. Still testing the effects of lots of HHO and no electronic enhancers.