Originally Posted by
dg2010
Thanks for the reply.
Think I will revert to running it straight for the time being and monitor how it behaves. Never anticipated having to run it off ground.
I am puzzled why when it is insulated that I cannot reach the amperage when run without the PWM.
Ok, This isn't making much sence here.... Insulating, or Isolating the unit shouldn't have any effect on attaining desired amperage, be it WITH, or WITHOUT a PWM.... Sounds to me like you don't have your E-Lyte concentration set high enough to draw your desired amperage...
The PWM Turns on and shuts off the power very rapidly, hence, the need for the ground to go to the unit. but, by no means, will the PWM the make the unit accept MORE amperage than it'll take... Meaning, if you have EVERYTHING dialed in (MINUS the PWM) so the Unit Pulls 10 amps, Then the PWM WILL NOT Make the unit run at 20 amps....
The PWM Will however, Drop, and Maintain a unit pulling 30 amps,to ONLY run on 20 amps....
96 E-250 4.9L, 100,000 Miles.
12.5 MPG Befor HHO
16.5 (Best) after HHO.
Modified Smack Gen I Cell.
85 BMW 524TD
26-32MPH
HHO Coming soon
A TOOL Is only as GOOD as it's operator. If the Operator DON'T KNOW How to work it, The TOOL WON'T WORK