hi, My dry cell production is just where I want it, But it gets hot fast. Is there any way of cooling it with out lowing my electrolyte mix. Would a PWM help? It runs at 23 amps 12v.
hi, My dry cell production is just where I want it, But it gets hot fast. Is there any way of cooling it with out lowing my electrolyte mix. Would a PWM help? It runs at 23 amps 12v.
You need to give us a whole lot more information about your system.
How is it configured? How many stacks? Neutral plates per stack? Electrolyte concentration? Ect..
Also, you mention that your production is just where you want it. How many LPM?
1998 Explorer 4x4, 4.0
14 cell / 2 stack 6x9" drycell reactor 28%KOH dual EFIE, MAF enhancer, IAT & ECT controllers, 2.4 LPM @ 30 amps. 6.35 MMW http://reduceyourfuelbill.com.au/forum/index.php
All right, 50 plate, -NNNNN+, not sure on the spacing, 8 gauge wire, sodium hydroxide
Ok, now I'm confused. 50 plates doesn't make sense. 49 plates for 8 stacks of 6 cells would be right. I don't get where the extra plate goes.
If you're running on 12 volts, what is the power supply?
1998 Explorer 4x4, 4.0
14 cell / 2 stack 6x9" drycell reactor 28%KOH dual EFIE, MAF enhancer, IAT & ECT controllers, 2.4 LPM @ 30 amps. 6.35 MMW http://reduceyourfuelbill.com.au/forum/index.php
1998 Explorer 4x4, 4.0
14 cell / 2 stack 6x9" drycell reactor 28%KOH dual EFIE, MAF enhancer, IAT & ECT controllers, 2.4 LPM @ 30 amps. 6.35 MMW http://reduceyourfuelbill.com.au/forum/index.php
Ohh sorry 49 plates, -NNNNN+NNNNN-NNNNN+NNNNN-NNNNN+NNNNN-NNNNN+NNNNN-, running off car battery.