Originally Posted by
BioFarmer93
Have you located a space where the drycell will fit? Also, there is not much to designing a drycell for an engine of 1400cc. Probably 13 plates, arranged [-nnnnn+nnnnn-] of 316L stainless steel, about 10cm x 25cm each. EPDM of 1.5mm may be used for gaskets with good results. You must find room for a make-up water reservoir and also a bubbler to cleanse the gas and prevent flash back. Finding room in the engine compartment for the equipment may be more difficult than actually designing and building it!