Hi guys,
I would like to say huge thanks to all of you, who have helped me to do the right away. I have now successful of making the bubbles. My next target is to make more bubbles and check out the amps in the circuits before I will do the hho production.
The first things I would like to know, how to make the bubbles with ALL plates??
The pics I have included, there are bubbles with one plate alone. I had input two KaOH mixed with the tap water (will only use it for now and needs to make more bubbles before I would use distilled water).
I do not know why there are bubblers with one plate alone, it should have make bubbles with ALL plates. However, I have carried out the test and you can take a look what I already have done so far: I uses 12V battery and I measured the battery using with digital mulimeter, the battery has got full of power in it (12.70v), I uses the battery clips on both side (one for positive and one for negative) with the 15A wires and connected to the stainless steel bolts on the top lid of the container with 15A ring terminals, inside the container I uses another 15A terminals with the same limit of the wires on both side to connected from the stainless steel bolts to the scraps, I uses another 15A terminals on both side to connected with the scraps and then the scraps connected to the cell. I uses the seven plates while I am still using plastic bolts on the cell to allows the DC current to get through in the circuits.
I think I am nearly there now, so I want to keep project on this until I get fully successfully. I would like one of you to help me out what I should do to get it right away....
However, my doubt is when I was working on the cell at the other day, I attempted to make more bubbles. I used tap water and I had input two KaOH mixed in the water while I carried out the tests to make more bubbles. When I made the bubbles, I was a bit suspected that I saw the steams between the cell and the water. I wasn't really sure what it was, if it was gases or the steams. Can you please tells me what it was and isn't it normal to have it between the cell and the water while I used KaOH mixed in the water??
I really hope that nothing are quite seriously. I knew that I shouldn't using tap water, but I will only using this for now to make some test to make sure that I make the bubbles with ALL plates even not one! When I done to make the bubbles with ALL plates, I will uses distilled water. It would be a waste if I uses them and disposal when I find something occurs. The good way for me is to not waste them will be using tap water for now until I get successful to make the bubbles for ALL plates and when I make the cell to get fully working.
I hope you will understand what I am trying to do, so please can you advice me how I could find out in a proper way to check out how much amps is in the current?
Any info would be much appreciate
Thanks!