Yes, because you all are lazy and none of you take notice on here to help me out for the last 24 hours.
I have a very difficult situation to get it working correctly. As I hope that you are awake of this.
My problem is I can't be able to make the bubbles when I take the reading of the amps or volts at the same time. I can only make the bubbles if I use WITHOUT the multimeter.
I have tested the battery with the wires without connect to the spacks cell, so the wires did up the volts as the reading are 12.53v. I knew that the wires and the battery are fully working.
I have added KOH in the water already 6 times, but it doesn't help.
Here's example of what I have done to measure the current:
Battery positive post ---- clamp meter ---- hho positive plate strap
Battery negative post ----------------- hho negative plate strap
And
Battery positive post ----------------- hho positive plate strap
hho negative plate strap ------clamp meter------ Battery negative post
When I measured the current of amps while I connected from battery positive post to the clamp meter and then to the hho positive plate, I have got the range of amps between 0.98A and 1.00A. There are 3.34V. I have tried to connected the multimeter between from the hho negative plate strap to the battery negative post, I am still on the same boat.
Do you have any idea??
Thanks in advance.