Howdy!
I built and installed my first wet cell with one bubbler in a 1988 toyota pick up; 4 cylinder carburetor. I ran the outlet of the bubbler to the air intake hose two feet away from the air filter.
I used 4" pvc for the cell and 2" pvc for the bubbler. They are about 9 inches tall. My bubbler has a rubber plumbing cap that is not ait tight (I didn't tighten the metal strap down). I read somewhere that it acts as a blow off if there is a backflash.
The bubbler was 1/2 full and the cell was 80% full of water.
I drove it 52 miles to work, it reached 28 amps peak and then backed down to 26 amps continuously.After it fully cooled I checked on it (4 hours). The bubbler is empty.
Is that because the cap is not air tight and the water is escaping from that? I am concerned that water is going into my engine.