Originally Posted by
KiaSoulHHO
Bhart,
Thank you for the compliment.
-Bottom inlet holes? Would it be a good idea to stagger the bottom hole in the ss plates so that the solution is diverted for better displacement?
Not for displacement, but to control volt leakage. You want the electrolyte holes as far away from each other as possible.
-Wire? I'm using a small 16AWG for testing only. I do plan on using 12 or 10 on the final build along with some type of lug and bolt so it will make a better connection.
10 ga., also bolt connectors to the plates.
-In and out ports. The inlet ports on the bootom are to be staggered. What about the outlet ports?
Staggering the ports themselves does nothing.
-Wire ties...great idea!
-leads in opposite corners. Are you talking about one on top left and then one on bottom right? If so does it matter which is + or -?
(+) on 1 side, (-) on the other. You can also make connections at opposing corners, ie: (+) top left & bottom right, etc..
Thank you for the advice!