I have not abandoned this thread or the idea of building bio farmers cell. I have been traveling alot and am still awaiting my plates to be laser cut. Since then I have machined and drilled and tapped all 8 bulkheads using .75 UHMW. My resovoir will be made out of a 2 Gal water container with a nice 4" screw on jar lid. I also am about 90% finished wiht my bubbler using 3" Poly Carbonate tube. All of my gaskets are cut out of Rubber Roofing material. Progress has been slow and steady. I also have been working on a custom PWM Module. I am looking at building a PWM capable of delivering 100+ amps from scratch. I have built a timing circutit using a 555 timer with a pot as a voltage divider. The circuit should ocsilate arund 144KHz. I am now in the process of building a parrallell mosfet bridge for the power delivery. I should have a nice picture by picture totorial after I am finished.
VIN 1GTHK33F0RJ737771
1994 K3500 crew cab 4x4 non- dually
Walt's Air Filter Upgrade
4" Turbo Back Exaust
No Muffler no Cat
Homemade Boost Controller
Boost Gauge, EGT Gauge, Trans Temp
B&M Transmission Aluminum Pan
Remote PMD with #9
Marine Injectors
Aftermarket cylinder heads
Walt's cooling upgrade w/Duramax fan and clutch.
199,000 miles
BF Goodrich A/T's. 265/75-R16
Reading, Pennsylvania