Safety Measures
Now that I have a good idea on material and construction of the Dry Cell, I now want to start thinking about some of the safety devices needed. Any recomendations? I was going to make a bubbler/resovoir out of 3"PVC with a rubber cap doubled as a blow off. Should I consider a second Bubbler? What kind of spark arrestor should I be installing? THinking of using a spark arrestor of Oxygen cutting torch but not sure of the minimum pressure required to pushh open the check. An accetylene spark arrestor would work but it would be left handed threads making it more difficult to addapt. Any thoughts? I seen some posts on a bubbler with steel wool etc. Any body have input on any of these?
VIN 1GTHK33F0RJ737771
1994 K3500 crew cab 4x4 non- dually
Walt's Air Filter Upgrade
4" Turbo Back Exaust
No Muffler no Cat
Homemade Boost Controller
Boost Gauge, EGT Gauge, Trans Temp
B&M Transmission Aluminum Pan
Remote PMD with #9
Marine Injectors
Aftermarket cylinder heads
Walt's cooling upgrade w/Duramax fan and clutch.
199,000 miles
BF Goodrich A/T's. 265/75-R16
Reading, Pennsylvania