Hello,

I'm totally new to HHO and plan on building a dry cell in the future. Before I do, I'm doing some experimentation with a wet cell, just to get the basics down.

I've been reading on the forum that you shouldn't drop more than 2v between plates. Does this also apply to wet cell construction? I'm assuming that this is only for multi-plate dry cells... I see a lot of 12v, two-plate, wet cells on utube.

I'm currently running mine at 24v because I just happened to have an old wheel-chair charger laying in my workshop. I'm sure that this way too much voltage, but I am producing HHO gas.

My electrodes are two S.S clip pieces from an old dishwasher. They are about 1/8 of an inch apart and are pulling 6 amps. Probably totally inefficient?

I also had a question about this video on utube:
http://www.youtube.com/watch?v=-3LVh...1&feature=fvwp

Wouldn't the slots in the Stainless spatulas really increase leakage current? ( I don't plan on making this, because I don't want to expend any money until I make my dry cell. I still would like to know, however.)

Just wondering.

Thanks in advance for any replies.