Uni Polar Cell well under way
I have used Tephlon tape on all my fitting connections. Is this a mistake? Thinking maybe I should have used GOOP or Silicone or something else. Also on my bottom pipe the fittings protrude up into the pipe further than the bottom ID of the pipe. Will this cause my electrolite to settle out and collect in this area? What is the best way to mix the electrolite. Warm or cold water? Or can I simply mix it at room temperature? Also once it is mixed will it stay homogenous or will the Lye settle out of the water in time?
Any other constructive critisism is welcome. Resovoir and bubbler are on the agenda for tonight.
VIN 1GTHK33F0RJ737771
1994 K3500 crew cab 4x4 non- dually
Walt's Air Filter Upgrade
4" Turbo Back Exaust
No Muffler no Cat
Homemade Boost Controller
Boost Gauge, EGT Gauge, Trans Temp
B&M Transmission Aluminum Pan
Remote PMD with #9
Marine Injectors
Aftermarket cylinder heads
Walt's cooling upgrade w/Duramax fan and clutch.
199,000 miles
BF Goodrich A/T's. 265/75-R16
Reading, Pennsylvania