So i'm wanting to build a dry cell(s).

My plates are 316

6inx2in Main Plates
12inx2in For connectors (I'm sure i'll be cutting these down to more around 6.5inx2in

31 6inx2in Main Plates
21 12x2in Connector Plates

My Gasket material is a rubberized crap i found at lowes on giant rolls. It is 1.01mm thick.

My goal is as high LPM as possible. I've got some Weld-On 16 on the way to seal the holes and edges of the plates. I'll be spending the day sanding and cross sanding the plates.

So whats the most efficient layout of my plates to get the highest LPM on 14v (car) and KoH. I'll be using this to fill jugs to blow up on the 4th

After that i'll convert it to something to use on the 1.6L engine.