http://cgi.ebay.com/ws/eBayISAPI.dll...T#ht_991wt_905
This is what my small gasket it.... the thicker gasket is 60 Durometer...
http://cgi.ebay.com/ws/eBayISAPI.dll...T#ht_991wt_905
This is what my small gasket it.... the thicker gasket is 60 Durometer...
My biggest problem with leaks was not properly sanded / sandblasted plates, especially where the gasket sits. Any durometer lover 65 will make your problem consistent and after dozens of bolt tight-ups you will end up with your gasket squized out and as thin as toilet paper.
Also, I use compression springs to compensate the sealing of the cell with any temperature change. Had to tighten my cell a few times after hot runs. After that no leaks between the gaskets, but the polypropylene sheets leaked between gaskets since their surface is polished. Had to sand them lightly too.
VOLVO VNL 670 '04, 12L D12D engine, ODO beyond 1.1M miles. Stock 6.0 MPG. Managing up to 7.3 MPG w/o HHO Cell, w/ straight flow muffler, EGRs OFF, AirTabs, ...
SMART HHO Dry Cell in progress: 10"x12" #20 316L 66 plates unipolar 6 stack, 200 AMP PWM, Fully monitored & controlled by .NETMF Platform. 7.33LPM @ 102A
My Youtube vIdiotics.
FUEL ECONOMY CONVERSION TABLE & FUEL EFFICIENCY FACTORS Cheat Sheet for Truck Drivers
CHEMICAL RESISTANCE GUIDE FOR PLASTIC AND METAL VALVES AND FITTINGS