Originally Posted by
koya1893
If you are going to built is yourself, you need to use 3/8 -1/2 HDPE end plates. Your 5.0 liter will require at the min 2.5LPM, you can produce that in two different ways: one built a two stack with 13 plates 12 cell configured like so: +NNNNN-NNNNN+ with this you can built it with two supply port and two exit port for the HHO. the (-) in the middle should not have any holes because you have two supply port and two exit port for the HHO. I use this configuration on the 4-5.4 liter engine. The plates I use are 3" X 11" for small and thin application.
the second option is built two seperate cells: -NNNNN+ and wire them seperately, meaning they have their own relay and fuse and should be able to run them "brute force". As I mentioned you need to find the means to have a 1.5gl reservoir to keep the system cool. the EFIE from Fuel Saver is the same one I use, you should yield good result with it. I recommend start high on the setting and work you way down to 300mv.