Reservoir Fittings Placement?

[jerrymc777]

Hello:

I'm ordering my first reservoir (3qt) but need some advice on the placement of the fittings.

If I tap and use location #1 for the HHO return from the cell, doesn't that prevent bubbles that could be sucked up into the manifold.
IE: Fitting #1 goes to dry cell output, #5 feeds electrolyte to the dry cell, #2 feeds HHO to engine. Locations #3 and #4 are not used.
(see attachment)

What are your thoughts?

Thanks!

[myoldyourgold]

If I tap and use location #1 for the HHO return from the cell, doesn't that prevent bubbles that could be sucked up into the manifold.
IE: Fitting #1 goes to dry cell output, #5 feeds electrolyte to the dry cell, #2 feeds HHO to engine. Locations #3 and #4 are not used.
(see attachment)

What are your thoughts?

Do not confuse the reservoir with a bubbler. You need both. In this case you would use 3 or 4 for HHO/electrolyte coming from the reactor. 5 could be used for a drain with a tube and valve. 1 or 2 used for exit to go to the bubbler.

Read this post:

http://www.hhoforums.com/showthread....5841#post45841