Page 2 of 2 FirstFirst 12
Results 11 to 18 of 18

Thread: The Honda car does not seem to accept the addition of HHO gas !!!

  1. #11
    Join Date
    Apr 2011
    Location
    Rimouski, Québec, CANADA
    Posts
    212
    Quote Originally Posted by koya1893 View Post
    IRENE has damage much of my house/shop. However, you need to start your EFIE at 9 0 clock and 250mv for the rear, re-set ECU run for two tank full, re-set and run on the same setting and then calculated MPG. Make sure you are feeding it at leasr 1 LPM.
    Hi,

    I made ​​the recommended changes.
    I think that 1 LPM is a lot but is worth a try

    thanks
    Remi

  2. #12
    Join Date
    Aug 2008
    Location
    Dallas, TX
    Posts
    490
    How many amps r u pulling to get 1 LPM? If it's close to 20 then that's way too many amps for that motor. Hondas dont have a lot of low-end torque compared to other cars. Also, if you have a distributor, you could try moving it counter-clockwise to set the base timing with a timing light. Yes this is the base timing adjustment not dynamic. 16-18 BTDC is normal so try either 14-16 or 19-20 and see which works better.

  3. #13
    Join Date
    Jan 2012
    Posts
    9
    Hi

    I have worked that vehicle a few times. I generaly get great gains with o2 spacers and a map enhancer. Since you have the o2 sensor EFIE try it with the map enhancer.

    Tune your map sensor about 15% down and you should be up to 35 miles per galon.

    Also increase your hho production to about 1lpm+

    I have archived 46mpg in one of those vehicles

  4. #14
    Join Date
    Apr 2011
    Location
    Rimouski, Québec, CANADA
    Posts
    212
    Quote Originally Posted by francodrr View Post
    Hi

    I have worked that vehicle a few times. I generaly get great gains with o2 spacers and a map enhancer. Since you have the o2 sensor EFIE try it with the map enhancer.

    Tune your map sensor about 15% down and you should be up to 35 miles per galon.

    Also increase your hho production to about 1lpm+

    I have archived 46mpg in one of those vehicles
    Thanks you

  5. #15
    Join Date
    Apr 2011
    Location
    Rimouski, Québec, CANADA
    Posts
    212
    Very very good result with new setup (LESS FOR MORE )

    100km highway, strongs winds, -3°C, approx. only 0.3 LPM HHO and NO EFIE ==> 48 MPG

    100km highway, no wind, -17°C, approx. only 0.3 LPM HHO and NO EFIE ==> 40 MPG

  6. #16
    Join Date
    Aug 2012
    Posts
    1

    How many amps

    Quebecker, just wondering how many amps your running to get the 0.3LPM?

    Thanks!

  7. #17
    Join Date
    Apr 2011
    Location
    Rimouski, Québec, CANADA
    Posts
    212
    Quote Originally Posted by bernanke View Post
    Quebecker, just wondering how many amps your running to get the 0.3LPM?

    Thanks!
    Approx. 4 amps
    Civic Si 4 doors 2004, 1.7 liters V-TEC
    5N2 reactor
    CCPWM @ 7 amp
    1 Gal Capacity
    ~2% NaOH
    Waterless Peat Moss Bubbler

  8. #18
    Join Date
    Jul 2011
    Location
    USA
    Posts
    340
    Quote Originally Posted by Quebecker View Post
    Approx. 4 amps
    Quebecker

    How is it going in your works, anything help with your HCS idea?
    Its done right or its not done !
    Hail HHO.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •