HHO Scam?
Originally Posted by
myoldyourgold
If you are going to try and run your engine much leaner than just the lean side of the ECU's maps then you should install an EGT (Exhaust Gas Temperature) gauge to make sure you do not over heat and damage or destroy your engine. In order to do this you would have to be an experienced turner which most are not. Using an EFIE and MAP or MAF controller is only going to have you run on the lean side of an acceptable range. This will do no harm to your engine and will give you some gain. If you think you are going to get a 50% improvement then do not waste your time.
I'm still gathering more parts before my actual install. I'm not expecting anywhere near 50%. (one can dream...lol)
I'm using a MAP sensor enhancer like this one.
http://cgi.ebay.com/ebaymotors/Dual-...item2a0eeaf296
Would a laser infra-red temp gun work to measure exhaust temperatures?
If so, at what point in the exhaust would I measure it? (IE: before cat. conv., after cat conv., manifold, etc...)
Thanks for the info again!
2000 Toyota Camry CE 4cyl 2.2L (CA emissions)
168K miles