With regards to wet cells such as the Aaron cell,
I see from site that ppl use tubes, plates, mesh. secondly that some desire high amps, low amps, high volts, low volts - ( high or low amps and high volts)
Q1: How do neutral plates make any difference?
Q2: Does the application make a difference in design?
i.e. car, truck, stove, home power
I am beginning to design a reactor as a home power unit using 4"x5" ss mesh.
with some-sort of radiator for extended use.
While I have seen units with extremely high amperage, I don't know where they are getting their amps from.
While I am thinking of running an old car/truck engine with new 350 amp alternators on-board, I have still not fully examined this concept .
Q3: Would it be better to generate extra HH and store it - and run the risk of explosion or to just make enough to run the generator?
Thanks 4 any help.